Re: Bearing advice needed (kinda long)

Posted by supergrumpy on January 13, 2006 at 06:58:32 from (24.213.235.108):

In Reply to: Bearing advice needed (kinda long) posted by MH on January 13, 2006 at 06:39:43:

if you are talking about the kind of bearings I see, the material will be very hard

why not turn down the axle shaft?, probably much softer metal

if you have some way of rotating it, you could use wet type sandpaper and reduce the size yourself, might just be a layer of paint or rust causing your interference issue

on 2nd thought, you might need that interefernce to keep the bearing in place unless there are snaprings or such

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]