|
Tractor Talk Discussion Board |
Bearing advice needed (kinda long)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MH on January 13, 2006 at 06:39:43 from (70.60.238.93):
I have an off-brand lite utility vehicle that I had to pull one side of the rear axle recently. The problem is that one of the axle bearings that pass through the frame was very difficult to remove (but I did without damage to the bearing). I see no way of putting it back on in its current state. To put it on I would need to press it on the axle. Unfortunatly I cannot put the axle back in the frame with the bearing on. Can I take the bearing to a machine shop and have the inside diamater increased by .001"? (to make it easier to slide on the axle) Or should I look for one that I can clamp down on the axle (the axle is 1" dia.)? Suggestions.
Thanks,
MH
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
