Tractor Talk Discussion Board |
Re: powerstroke in trouble
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mydeere on January 12, 2006 at 16:10:16 from (4.245.191.181):
In Reply to: Re: powerstroke in trouble posted by ILL John on January 12, 2006 at 13:42:58:
The point of my reply to Mr. Bill was that the 6.0 has plenty of power. It had nothing to do with serviceability. The 7.3 is no gem either. I don"t really enjoy taking an oil bath while changing the oil filter not to mention that its leaked oil like the Exxon Valdez from day one. And not that the 6.0 would be any better but changing glow plugs is not much fun either. Both engines have thier good points and bad points. But the 6.0 has more power than the 7.3 and that was the point I was making.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|