Tractor Talk Discussion Board |
Re: needed cutting edge for dirt scoop
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 4020 on January 02, 2006 at 20:46:25 from (216.139.97.163):
In Reply to: Re: needed cutting edge for dirt scoop posted by Don-WI on January 02, 2006 at 09:44:23:
The cutting edges are three different bolt ons. the two outside pieces bolt on and bend up at outside edge. Center part is a flat piece that sticks out front 4 or 6 inches. I call it a frost bit.I have been welding on new edges or blowing new holes in new edges to make it work for years.I guess thats what I will have to do again.Thanks for the ideals.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|