Tractor Talk Discussion Board |
Re: Airplane Turbinevs.Motor for TractorPull?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aaron SEIA on December 18, 2005 at 19:12:33 from (209.152.112.211):
In Reply to: Airplane Turbinevs.Motor for TractorPull? posted by Kirk K. on December 18, 2005 at 17:48:07:
Several guys I've seen pull use them. Wayne Longnecker uses a Merlin V12 with a metric ton of cubic inches. There are a BUNCH of Allison V12's out there. Have seen a couple of people pull turbine engines out of helicopters. Trick is, it's not like you call up Dennys carb shop and get a stroker motor for the things. Mega bucks to build, mega bucks to run. Guy I talked to at the Iowa State Fair thought it'd take a grand or so to buy an Allison. No idea how much it takes to switch to alcohol and add 2 turbo's. If you want a 6 banger aircraft engine, I've got a Lycoming I'd sell cheap. Think it's stuck though. Aaron SEIA
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|