Tractor Talk Discussion Board |
Re: Old Wive's Tale?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David A. Hodson on December 15, 2005 at 04:17:37 from (69.128.206.90):
In Reply to: Old Wive's Tale? posted by Allan in NE on December 14, 2005 at 18:06:02:
Allan, I had a neahbor that had a 966D Hydro, and a 1026DT Hydro, the 966 he bought new in 1972 and we bought it off of him when he sold out in 1989 with over 7K hours and never had touched the hydro not even to change the filters or fluind. Both tractors were used for all aspects of farming from heavy tillage to the feed grinder, even though my 766 could pull the same equipment. so they'll do it but not as effective. David
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|