Tractor Talk Discussion Board |
Re: Massey F 4840 questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by edchiansaw on December 12, 2005 at 19:28:03 from (152.163.101.7):
In Reply to: Re: Massey F 4840 questions posted by the tractor vet on December 12, 2005 at 13:16:30:
We have a 4840... we done a good bit of checking on it before we got it. its a 903 cummins v-8 and these were DOGs in trucks; however from the local cummins licenced repair center they made good tractor engines... the 4840 was a 260hp (engine) tractor and the rears ends are pretty good. from what we were able to find they are really good machines. our 4840 has 5600 hrs nothing done to the engine at all! 2 bearings replaced in drive line and 1 small seal leak on an imput shaft.. however.. THE 3pt hitch controls do tend to stop working.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|