Tractor Talk Discussion Board |
Re: Greatly needing help with key switch for 1967
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 37 chief on November 29, 2005 at 17:36:31 from (192.59.66.138):
In Reply to: Greatly needing help with key switch for 1967 Ford posted by K-9 Cattle Ranching Syste on November 29, 2005 at 17:08:47:
Too late now, but you could have taken a door lock to a lock smith, and have a key made. Old GM cars used two different keys. Ford used one for the door and ign. You can jumper directly to the coil from the pos. batt conn. If I am not mistaken there is a plus on the coil put the hot there. The pos batt connection should go to a selonid. again jumper batt pos to one of the small wires on the solenoid. This should energise the starter.MAKE SURE TRUCK IS OUT OF GEAR.IF IT SHOULD HAPPEN TO START IT WILL TAKE OFF. Hope this helpes If I am wrong I am sure someone will correct me. Stan
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|