Tractor Talk Discussion Board |
Re: carb problems on Farmall 300
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on November 28, 2005 at 12:41:41 from (195.93.21.101):
In Reply to: carb problems on Farmall 300 posted by al bane on November 27, 2005 at 13:27:37:
Not sure what you call a slight miss. Start with a compression test, or looking at the plugs to see which cylinder is burning different. Have you serviced it? Valve clearances? Plug wires? Plugs? Anyways, try to find out why it is missing. Sounds like you can buy carb after carb until the cows come home and it will still miss! A bit of a money waster there! What did these 5 people do? Did you specifically ask them to clean the carbs? Better to get someone to work on the rest of the motor to find the fault. Mag or dist.? Could be a worn lobe, not opening points properly, crack in distributor cover, etc, etc. Could be a worn lobe on the engine camshaft, not opening a valve completely. Does it use oil? A broken ring? Worn valve guide so a valve won"t seat properly? Just a few more ideas. RAB
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|