Tractor Talk Discussion Board |
Re: tire repair
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by msb on November 25, 2005 at 15:23:02 from (12.210.167.23):
In Reply to: tire repair posted by Tammy McCourt on November 25, 2005 at 14:10:14:
There are a number of things you can do.The first is to remove the valve core so as much air as possible can get in the stem.If it is a small tire you may be able to use a motorcycle strap to spread the tire,but be ready to get it off if the tire seals.You could also install a tube in the tire and not have to worry about it happening again.IF the wheel is off the tractor,sometimes it can be blocked up underneath so the bead will close off the gap and get to seal that way.You could borrow a Bead Cheta tank and reseal it that way.There is also a vegetable grease,bead sealer, from Frey that can be packed around the rim to seal it off long enough for the bead to seal.It works but is messy to use.The last and a very dangerous way is to squirt some either in the tire and then throw a match into the either.I have never seen that nmethod to seal.Howeever the Bead Cheta is the safest and easy way to do it.Just a big blast of air that is shot into the tire and it forces the sidewall to seal on the rim.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|