|
Tractor Talk Discussion Board |
Re: Right size of Mower for tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick L on October 18, 2005 at 17:39:45 from (172.171.178.33):
In Reply to: Right size of Mower for tractor posted by Tramway Guy on October 18, 2005 at 07:03:48:
I have had a 5 foot finish mower and a 5 foot brush hog that I have used with my Symplicity 9523 which is the same as the Allis 5020. Both work just fine with it. They cover the width of the tractor plus. I have a loader with a 4 foot bucket. It is just slightly wider than the front tires but the rear turf tires are a bit wider. I chopped four acres with the brush hog two feet higher than the tractor in second gear this summer. Only problem was the screen in front of the radiator plugged and caused it to over heat about three times. I bought it new in 1980 and have used it rough all these years. For over ten years I mowed over ten acres of grass. Still starts and runs like a champ.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|