Re: Bent Push Rod Question

Posted by Sloroll on October 17, 2005 at 06:14:16 from (69.66.221.164):

In Reply to: Bent Push Rod Question posted by Dave in GA on October 17, 2005 at 05:42:44:

I have straightened many pushrods and reused them. More than likely you aren't going to be really working this tracor again. There should be no noticeable loss of power for parading or display. Even the limited plowing you may do should be fine. If it were a high RPM engine or a heavily used work tractor it should be replaced. Make sure the valve is not sticking anymore, straighten the rod and replace it. If you stumble over another push rod put it on the shelf somewhere as a just in case.

Follow Ups:

• Re: Bent Push Rod Question RustyFarmall 06:45:45 10/17/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]