|
Tractor Talk Discussion Board |
Re: Woods 6' HD Rotary Cutter, how much HP is need
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 37 chief on September 04, 2005 at 22:32:09 from (68.7.223.14):
In Reply to: Woods 6' HD Rotary Cutter, how much HP is needed.. posted by Scott in IN on September 04, 2005 at 20:11:49:
I have a woods 6 ft. It weighs around 850 lbs. I have it mounted on a MF 203 which is a industral tractor, and is a little heaver than the farm tractor. It has the standard perkins 3 cyl diesel with arond 35 hp. This hp is enough to pull my mower in some very thick stuff. The only problem you may have with a smaller tractor like this is keeping the front end on the ground. My MF 203 front end stays on the ground, but when I put it on my MF 231, which is a farm type tractor, the front end is a little light. You may need a heaver tractor with that heavy of a mower. Stan
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
