|
Tractor Talk Discussion Board |
Re: Gas in oil on Farmall Cub
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on August 21, 2005 at 11:20:57 from (66.226.37.114):
In Reply to: Gas in oil on Farmall Cub posted by Cow Bird on August 20, 2005 at 20:02:30:
On the Cub the carburetor hangs below the intake manifold. Fuel would have to flow up into the manifold, then up through the intake passages to even get to the valve guides, much less into a cylinder. Long before that happened the engine would be hopelessly flooded with no chance of firing due the rich mixture. The carburetor has a drain vent on the very bottom so that a stuck float or leaking needle would dump the fuel on the ground. It would help me for these other folks to explain how the gasoline can get into the crankcase on a CUB. Certain other tractors, sure. But this question is about a Cub.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|