|
Tractor Talk Discussion Board |
Re: OT Pellet stove Inquiry !!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Coldiron on August 11, 2005 at 15:19:10 from (207.200.116.199):
In Reply to: OT Pellet stove Inquiry !!!! posted by Jerry Castleberry on August 11, 2005 at 07:43:27:
Jerry, We had a Pellet stove for about 6 yrs. The draw back to it was if there was a power bump it would go to high fire and stay there. I fought the company to wire around that part since we came home one day and the house was over 100 deg inside. A power bump while we were gone almost turned it into a house fire. We have a pellet furnace now and use 6 tons each winter in Northern panhandle of Idaho to heat our 2800 sq ft home. It will get as low as 24 below 0 with NO WIND. The secret to having them work good is to keep the heat exchanger clean. Mainteance during use is a must. The auger motor went out last winter at a cost of 165.oo from the manufacturer, Trager. I found the same one with a different brand name for 53.oo at a local supply house.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|