|
Tractor Talk Discussion Board |
Re: fence stays
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith-OR on July 31, 2005 at 22:10:00 from (207.200.116.199):
In Reply to: fence stays posted by StuBC on July 31, 2005 at 16:25:14:
Get yourself a piece of 3/8 pipe longer than your needed stays. using wire of same gage bend it so it is at least 6 to 8 inches longer than stays you need. clamp the piece of pipe in bench vise, push wire through pipe, clamp loose ends with visegrips so it will not turn. Put rod through the loop end of wire twist the amount of turns you would like to have in your stays, cut to length. Pipe will keep the wire straight will twisting....HTH...Keith...clear as mud!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
