Re: shortening PTO shaft with zerk fittings

Posted by old on July 29, 2005 at 09:31:31 from (207.69.138.202):

In Reply to: shortening PTO shaft with zerk fittings posted by JB OH on July 29, 2005 at 08:53:29:

You will probably need to cut the yoke off as bob said but it can be done in a home shop. You do need to make sure you keep it stright and you also need to keep the U-joints in time. Which is not hard to do either just make a note of how they line up now, cut off/grind off the weld where it hooks to the yoke and then weld it back up alineing it the same as it was. The last one I did took me about and hour.

Follow Ups:

• Re: shortening PTO shaft with zerk fittings JB OH 09:39:02 07/29/05 (1)
  • Re: shortening PTO shaft with zerk fittings old 09:48:34 07/29/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]