|
Tractor Talk Discussion Board |
Re: Why narrow front tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 28, 2005 at 13:41:31 from (216.183.136.2):
In Reply to: Re: Why narrow front tractors posted by txgrn on July 28, 2005 at 07:11:47:
I would have to agree that narrow front tractors don't get driven into as tippy situations that a wide front gets driven into. I should get a couple of the kids toy tractors and tip them sideways and angle ways on a board. To see if the wide or narrow front is more stable.My bet says the wide front will stay upright a couple of degrees farther than a narrow. It takes only bumpy ground at modest speeds on a moderate side hill to roll any tractor. A narrow front tractor may have had the rear wheels set narrow for rowcrop use. The wide front tractor may have a wider stance and be more stable. Because the wheels are set right out flush to the ends of the axle from the factory. Not too many people go through the work of regularly changing rear tread widths. Around here the collectable narrow fronts are all set with the rear wheels out flush to the axle ends. At some shows I've seen narrow front row crops with the rear wheels set as narrow as possible. The sides of the tires are "almost rubbing the operator's foot rests". They look like a couple of kids could tip them over with a good push.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|