|
Tractor Talk Discussion Board |
Re: 220 wire size Hello buickanddeere and T-Bone
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 28, 2005 at 11:02:45 from (216.183.136.2):
In Reply to: 220 wire size Hello buickanddeere and T-Bone posted by john in la on July 28, 2005 at 10:25:57:
Don't worry. It's mostly questions such as the following that get the scathing remarks. Requests for info that is are clearly stated in the machine's manual(s). Lead additives for unleaded fuel, single weight Vs multi weight oils, oil change intervals and detergent vs. non detergent oils. I assume this AC system is setup 40ft from the building�s power distribution panel? There must be a resistive heating system built into the inside evaporator unit when it rated for 60.0 Amp? I wonder what the 30.0 amp is for? That's an awful large fan? Is this a water sourced heat pump or something? Most electrical codes and common sense requires a single isolation point be able to de-energize the whole AC system. Depending on which loads are motors and if they are centrifugal fans, scroll compressors or reciprocating compressors. The starting inrush current amount and duration of the inrush affects breaker and wire size. This maybe a situation where a common supply over to a main disconnect and local breaker panel right at the AC unit maybe required? Getting into wire this size I like to run it in conduit. It's certainly not any more expensive and it's well protected. Measuring a string pulled through the conduit then cutting the wire to length right off the venders rack reduces waste/$$$. Just depending, driving a ground rod(s) right at the outside AC unit maybe required or just a good idea. If trenching conduit into the ground, laying the bare #6 ground cable in the dirt works very well.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|