Tractor Talk Discussion Board |
Re: E85 usage
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on June 29, 2005 at 06:40:35 from (216.183.130.92):
In Reply to: Re: E85 usage posted by ChadS on June 28, 2005 at 15:16:03:
If you about double the size on the injectors and upgrade the fuel pump thye will sometimes run 1/2 decent even with the gasoline software. It's that running lean and the computer calling for max injector pulse width at that rpm/thottle position/map pressure/flow meter. And still not getting the O2 sensor to reach about .7V that confuses things. About the highest flow high impedance disk injectors which I use in the National are 42lb 007's. There is a 50lb pintle high impedance out there too. Any higher flow and the injectors are low impedance "peak & hold" design. The origional computer drivers will work if the transistors are swapped out for high current models.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|