Tractor Talk Discussion Board |
Re: What's a good digital camera???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 720Deere on June 22, 2005 at 15:34:42 from (70.17.246.102):
In Reply to: What's a good digital camera??? posted by Ray on June 22, 2005 at 14:52:32:
Anything over 3 megapixels will work just fine. The Kodak cameras are fine as far as user friendly and quality of picture. We use them at my work (heavy construction) and have over 30 of them. We have little to no trouble with them and the pics are fine. The only complaint that I have about the Kodak is that they are slow to save the picture on the card. I have a Sony that will snap pictures at 5 MP all day long as fast as you can click. Not much difference in the picture quality just user preference.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|