311 hayliner, timing out again!!!

Posted by Hurst on June 05, 2005 at 16:08:54 from (204.255.227.137):

I got it together and the knottoers were working fine, but the plunger stop keeps hitting the arm. I reset the timing 2 times today in the fields (lined up all the dots), but right as it is about to finish tying the bale, the shear pin snaps and the timing is out. I had to put an extra shim on the knotters so the gears wouldn't jump and they are working fine. I was wondering, the plunger stop is not flush when the plunger is all the way back, but it doesn't hit the plate and rubber stop. Does it need to be pulled back further and would the problem be that it is hitting the plunger while the needles are all the way out of the bale, but not all the way down yet? Thanks in advance.

Hurst

Follow Ups:

• Re: 311 hayliner, timing out again!!! Joe(TX) 09:27:32 06/06/05 (0)
• Re: 311 hayliner, timing out again!!! RickB 16:15:43 06/05/05 (1)
  • Re: 311 hayliner, timing out again!!! TimS 09:02:40 06/06/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]