|
Tractor Talk Discussion Board |
Re: steering/clutch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1486 on May 01, 2005 at 19:01:16 from (204.77.167.89):
In Reply to: steering/clutch posted by 1486 on May 01, 2005 at 15:05:51:
Tractor vet, sounds like you have alot of experience with these kind of probs. If it is only acting up now and then and I test it while it is acting normal will I get a normal pressure reading or will it still read low.If it is sucking air between the range and speed trans do I have to pull top shifting covers off to get to that or where is the pickup tube r o ring. and do you know which valve would control this> I have followed the tube from the bottom of the Mcv pump housing and it goes to the other side of the tractor. to a housing that is next to the hydraulic control valves.Can you buy rebuilt MCV pumps.(I'M SURE they costly)or how hard are they to rebuild. Dad said he did a pump on a 560 one time and it wasn't to bad
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
