|
Tractor Talk Discussion Board |
Re: Honda 3813 engine surging
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wizzy on April 25, 2005 at 18:43:20 from (205.231.145.50):
In Reply to: Honda 3813 engine surging posted by Brad K on April 15, 2005 at 14:58:20:
I have 1 and if you leave it outside or if mice have gotten into the magneto/area they sometime make nests in there and when you start it up the nesting stuff may cause timing belt to slip and then timing will go off.doesn"t matter whay you do to try to adj. it out,it just won"t run right.A honda mech .told me about this problem. If you look below battery at rear of engine down at bottom of rear cover you can,if you are looking in just the right place,see a black plastic cover (and inspection hole) if you see alot of grass and stuff in any of those small openings then ,chances are you had a visitor. I was able to remove debris and reuse belt ( it was alittle loose)but after reseting timing marks it now runs like a top again .Hoipe this helps Jim
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|