Re: Chisel Frame

Posted by John A. on April 23, 2005 at 18:04:37 from (65.161.170.163):

In Reply to: Chisel Frame posted by Allan in NE on April 23, 2005 at 16:01:39:

Allann There is No doubt you new girl will pull 9 shanks , just a Screaming and a Flying!. I am not sure about your termonoligy of "open field chiesel"
A standard chiesel plow like the 3pt-13 shank Graham-Hoame I have is 3 - 4x4 cross beams with shanks in a 4-4-5 configuration.
A single 5x7 tool bar is a he!! of a tool bar.
If you are planning on only one foot apart it would probablly be all right though I would crenge in hard packed ground. If you are planning on useing it as a a 9 row ripper on the middles on cirles, I am afraid you don't have enough tool bar to do that! We had a 7 row Orthman middle ripper, It had a 10x10, or 8x8 tool bar I don't remember now. pulling it with a 4840 w/ straddle row duals. 14 to 16 in deep was all we could get out of it and keep any kind of speed. At that point you could watch the tool bar rainbow back in hard pulls. You could forget about running it without the duals.
I am sure Hamby or Orthman, or someone makes a mount that will put that shank on a 5x7! Hope this helps.
Later,
John A.

Follow Ups:

• Re: Chisel Frame Allan in NE 18:50:46 04/23/05 (2)
  • Re: Chisel Frame John A. 05:23:38 04/24/05 (0)
  • Re: Chisel Frame msb 21:46:50 04/23/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]