|
Tractor Talk Discussion Board |
More Trouble
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 37 chief on April 16, 2005 at 21:30:26 from (68.7.225.45):
Had the old JD 5020 going again today trying to finish the 20 acre discing job. This should have been done in a few hours, but there is a lot of turning and very steep areas. I was going real good and I hit a wet spot, and down we went. I had instant flash backs to some of the pictures I have seen on stuck and troubled. Part of the problem was the disc hyd hose became disconnected, and I could not raise the disc in time. Hooked hose up again and raised the disc, and just barley made it out. With all that My question is: do the tractor break away connections become weak, causing hoses to pull out very easy? By the way thanks Allan for the tip on how to relieve pressure on the hoses, a little messy , but it works. Stan in calif.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
