|
Tractor Talk Discussion Board |
Re: OIL, what do you guys use?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jay (ND) on April 05, 2005 at 09:16:17 from (66.231.118.192):
In Reply to: OIL, what do you guys use? posted by caseyc on April 05, 2005 at 07:18:31:
I won't give you any specific recommendations, but here is what your tractors ask for. The 706 wants a sulfated ash of not more than .5%. Above +32 30, below 32 10W. The 766 does not specify an ash content. +32 30w, below 32 10w. The diesel may also use 15w40 above 15 degrees. WD45 Allis? If so, that specifies 30w for temps 40-90. No ash content specified. I guess I would compare the ash contents of the oils you are considering, but would stick with the 30w. Ash content is relatively low in most modern oils, but may not meet the .5% that your 706 wants. Whether an extra .1 or .2 is enough to worry about, that is your decision.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|