Tractor Talk Discussion Board |
Re: Please teach your kids to drive....a little OT
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Edchainsaw on April 01, 2005 at 20:46:09 from (64.12.117.7):
In Reply to: Re: Please teach your kids to drive....a little OT posted by Gravy on April 01, 2005 at 09:15:46:
I drive a truck a bit... I agree I have so distane for the ones that drive by my house.. I got passed the other day on a 2 lane going up a hill (I was only doing 50 --but 55 is the limit) he almost cut me off to keep from hitting the oncomming cars.. they stopped for him.. he then drove 1mile farther to the coal mine..... oh and that was just the last time he did it to me.. he's done it before. I was given the responsibility for driving a truck (an army duce and a half) when I was 3... I failed. so I was not let drive again till I was 5. (I did the swinging arms stuff on the wheel-when dad needed it held straight to load hay)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|