|
Tractor Talk Discussion Board |
Indydirtfarmer others (pic.)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Richard H. on March 31, 2005 at 10:05:10 from (4.225.17.47):
This trailer frame used to be a 28 ft travel trailer until there was a mystery LP gas explosion that blew the camper off. It was,,, a double slide so the GVW was probably 7000+ lbs. It is a 2002 frame with only 400 Miles on it meaning the tires and brakes perfect.
Unfortunatly one of the now gone camper wizards at our family campground had already started hacking on it before I got it. The bed frame now is 18 ft which is enough,but close for my 861 and bush hog.
I want to put 30 in long angle drops on the back at 15 degrees or so to support fold up ramps.
On top of the frame I want to make a 4 in channel iron frame for the bed OVER the tires so I dont"t have fenders,(more width). Using 5/4 deck wood for the floor with 2 1/2 channel for cross bracing. Before I go any farther with this thing I would really like imput from you all to tell me if the frame is strong enough?
Is 31 inches to tall to safely get the tractor on and off of?
If so, how long should the total lenght of the ramps be? Any thoughts would be nice.. Richard
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
