Tractor Talk Discussion Board |
Re: can I make a massey fergosun 850 a dually comb
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by edchainsaw on March 03, 2005 at 20:20:37 from (205.188.117.7):
In Reply to: can I make a massey fergosun 850 a dually combine posted by Mark Perreault on March 03, 2005 at 20:01:37:
I grew up around these machines--- our 850 had the same size tires as our 860 did but if you mean 30.5x32's I dont think I would dual those. there is a huge amount of torque put on the final drives when you do that.. we had only minor problems with the final drives but never dualled one. our 760 and our 850 both blew out final drives and if memory serves me right they are the basically the same. I am not saying you cant do it. oh and I know a former massey service teck that won a bet putting 2- 20ft swaths of wheat at the same time threw a 410 so I know an 850 will take it
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|