Tractor Talk Discussion Board |
Re: Cummins Tools
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thejdman01 on March 03, 2005 at 09:04:46 from (207.63.16.46):
In Reply to: Cummins Tools posted by Tweeter on March 03, 2005 at 07:20:37:
i have had ntohign but bad luck with the traveling clowns. again freight if you ever have any problems or trouble will kill you. locally star line a very very cheap and knowledgeable local that does any electric work anything at all from starters off a toyota to a starter off a dresser loader and rebuilds computers circuits anything electrical this guy is a real gooru and works very cheap 30 bucks usually labor for a total teardown of a starter or altenator and rebuild. he even bumps altenators. like for my 6.5 diesel the chinsy 80 really wouldnt cut it with the plow on etc and he bumped it to 160 amp and replaced brushes and bearings regulator while he was in there for 110 bucks you cant even go to the parts store and get a rebuilt 80 amp for under 150 but anyways going off on a tangent had a cummins drill press once and motor burnt out took it to him and he said it was the biggest piece of junk he had ever seen poor quality poorly made cheap. wnded up putting different pullies, motor etc on it now aint too bad. as much as i hate sears i would go somewhere that you can take it back yourself. some of those traveling shows have real good deals especially for the homeowner but some are real flyby nights
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|