Replacement hardware for Loaders

Posted by Paul_NJ on February 24, 2005 at 20:58:21 from (70.21.244.125):

I just bought a 1701 loader for my International 340. Got a good price ($350), but it's pretty rusty from sitting outside. Arm cylinders are fine, but the bucket cylinder leaks and needs to be rebuilt. But that's all do-able. Here's my problem: the holes the pins go through where the arms pivot to the frame are worn and elongated from wear. The pins are almost falling out. I've been told that this is a common problem with used loaders and backhoes and that replacement pins and bushings can be purchased. Apparently you weld the bushing plate over the top of the old hole. Does anyone have experience doing this? Where would you find parts such as these - I assume they are generic and not necessarily IH items.

Follow Ups:

• Re: Replacement hardware for Loaders jdemaris 06:25:14 02/25/05 (0)
• Re: Replacement hardware for Loaders george md 22:30:22 02/24/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]