|
Tractor Talk Discussion Board |
Re: Used New Holland 8970 Purchase??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G/MAN on February 18, 2005 at 13:48:35 from (67.52.48.10):
In Reply to: Used New Holland 8970 Purchase?? posted by JHock on February 16, 2005 at 17:57:58:
I worked on New Holland Genesis tractors for three years or so. It's not uncommon for one of the early ones to be pretty hot on the dyno. 300+ horsepower is a bunch out of a 7.5 liter diesel, but I've heard of other 8970s running that much smoke. Be forewarned that the Genesis blocks are parent-bore with no sleeves, so rebuilding requires either a hone job and rings if the cylinders are still within wear specs or a bore job, new pistons and rings. Although I don't think I'd worry to much about the hours being "turned back", as the tachometer/hourmeter is electronic and contained within a controller, I would maybe be worried about a Genesis with 3500 hours that hadn't had any other work done to it. Several years after they came out, we were still getting several Service Bulletins per month on them. One of the most common problems was a leaking front seal, as the steel sleeve on the front of the cranks wasn't hardened properly, and the seal would cut into it and cause a leak within the first 1500 hours or less. Look for a leak there. They also seemed to be pretty hard on A/C compressor clutches. I replaced several of those. If it's a Super-Steer tractor, there are a ton of grease zerks on the front end. Make sure they've all been greased. But, generally speaking, they're a strong and relatively trouble-free tractor, and would be my first choice after a Deere 8000 for a big row-crop of that vintage. If you have any other questions I could possibly answer, feel free to email me at [email protected].
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|