Tractor Talk Discussion Board |
Re: Deere parts - shipping handling
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thejdman01 on February 03, 2005 at 06:28:42 from (152.163.101.7):
In Reply to: Deere parts - shipping handling posted by msb on February 02, 2005 at 18:49:06:
i ordered 2 keys for my toolbox from sears. keys were 3.69 a piece. and shipping and handling for 2 keys cost 4.50. 4.50 to ship 2 keys you want to know ridiculous that is spending 11 bucks and change for 2 keys but i coudlnt get them cut anywehre as they use a special blank w/a groove in the center and cut on both sides. this is another story but w/these automated machines and the flaming morons at the local hardware store w/the automated machines and their brain power claim they cant even cut 2 sided keys at the rockford menards. i never knew it was hard to cut a key but now it is all automated
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|