Tractor Talk Discussion Board |
Re: J.D. 730D
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on February 02, 2005 at 13:51:26 from (192.75.48.150):
In Reply to: Re: J.D. 730D posted by Mydeere on February 02, 2005 at 08:01:52:
The flywheels were OK if the operator followed the service manual and retorqued the flywheel with a torque wrench. The trouble often started shortly after an engine rebuild or an end play adjustment. Too little and she will shake loose. Too much and the bolt threads stretch and clamping power is lost. By guess and by golley with a piece of pipe on the end of a breaker bar is sure trouble. To use a torque wrench just weld up an off set from an old wrench and socket. Any time when working on those flywheels toss the old fasteners away. New grade 8 bolts, hardened washers and tall grade 8 nuts. 275 -300 lb ft oil with cam assembly lube. Or 350-375lb ft clean and dry.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|