Tractor Talk Discussion Board |
Re: LUC J.D. Valve Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene Davis (GA) on January 09, 2005 at 19:43:41 from (66.82.9.48):
In Reply to: LUC J.D. Valve Question posted by Larry D. on January 08, 2005 at 19:19:39:
Remove the spark plugs and put some upper cylinder lubricating oil or something of that nature, and with the plug out slowly turn the engine a couple of revolutions occasionally for a couple of days, Don't try to turn with the plugs in place, oil won't compress, and the rods may bend. After a couple of days the oil will probably all drain by the rings and valves then will not endanger the engine. You will probably need to change the oil anyway upon starting engine and it will smoke fiercely for a few minutes on startup.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|