|
Tractor Talk Discussion Board |
Re: Solid state voltage regulator for a generator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gerald J. on December 31, 2004 at 06:47:00 from (67.0.108.37):
In Reply to: Re: Solid state voltage regulator for a generator posted by Bob on December 30, 2004 at 19:16:39:
In the alternator, the rotor is the field. In the generator, the field is the stator. Works the same. Except the rectifiers in the alternator also do the cut out function while the rectifier in the generator (the commutator and brushes) doesn't do the cutout function. I found that the diode cutout was far superior to the relay cutout because at 6 volts it didn't take 10 amps reverse current to trip it out. When I last posted, I forgot that I did a solid state regulator for the turbine generator and the Boone and Scenic Valley Chinese locomotive a couple years ago. That generator was rated to do 50 volts but they used up the world supply of 50 volt quartz lamps and now use 32 volt quartz lamps and my regulator keeps them working far longer than trying to regulate the voltage by steam pressure alone on the turbine. For 6 volts my MOSFET would have to be logic rated and I might have problems turning it off from my chosen regulator IC. The relay type voltage regulators were allowed to hold a 12 volt system between 12 and 15 volts, a 6 volt system between 6 and 7.5 volts. The battery is happiest at 14.2 volts or 7.1 volts and gives far better life so the solid state regulator that does that precision is far better for the battery (and the lights). Gerald J.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|