|
Tractor Talk Discussion Board |
Re: OT: Tips/ideas for pole barn, do's/dont's.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cootbruce on December 26, 2004 at 11:24:35 from (24.213.27.142):
In Reply to: OT: Tips/ideas for pole barn, do's/dont's. posted by Markss on December 26, 2004 at 09:07:03:
I am not a carpenter, but I did build my own 30x42 building, a manards kit. I built it in about 2 weeks, long days but it can be done. I poured my floors inside the building once it was up. Pour them in three sections, center section first, then the two side sections. They turned out great. Did all my own wiring too. Now I am insulating, doing it all in stages over about three years. I have about $10,000 total into the project. If you can do it all at once do it that way. My problem was money, more time than money so I did it in stages, the problem with this method is....you fill your shop up with "stuff" then when you have the money to do the next step, you have to move all that stuff. I am insulating my walls now. I move everything from one side to the other, insulate and move it back....better to do it all at once, BEFORE moving into it....
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|