|
Tractor Talk Discussion Board |
Re: What's better 1066 0r 4440
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G/MAN - Hey Cliff... on December 16, 2004 at 10:36:32 from (67.52.48.10):
In Reply to: Re: What's better 1066 0r 4440 posted by Cliff Neubauer on December 15, 2004 at 16:09:10:
Shall we do a little 5088/4450 comparison, since that would be the proper Deere to compare your 88 to, instead of a mid-70s 40-series? I noticed you kind of skimmed right over that little fact in your replay. And BTW, your flow specs are low even for the 4440, let alone the 46 or 48. Maybe you'd better find some REAL numbers, instead of supposing. I'm also laughing about the "high capacity" front axle. Why didn't they just put a decent axle in them as standard equipment? I don't care if they do still use them, they're still overly complicated and have twice as many moving parts to wear out as a Deere.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
