Tractor Talk Discussion Board |
Re: A great homebrew generator plan
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by willie j on December 07, 2004 at 03:48:15 from (205.188.117.7):
In Reply to: A great homebrew generator plan posted by Jake In Colorado on December 06, 2004 at 19:05:54:
Jake You guys are to be commended for thinking about this, keep at it. However, it won't work. Energy cannot be created or destroyed. It can be changed in form & moved around. I see a few weak points. All energy comes from the sun. No machine is 100% efficient. Bearing friction, belt friction, some of the electrical energy, & even slight air turbulance of the rotating shafts are converted to heat & dissipated into surrounding air. The most efficient way that i am aware of, although there may be others, is to grab the sun's energy, bypass everything else, & convert it directly to electrical energy. Then it can be stored in batteries for use when there is no direct sunshine, & moved by wire to wherever it is needed. There is a field of solar collectors about 35 miles west of Barstow Ca, looks like about 80 acres. Don't know if this is experimental or in use. Wind energy is a big project too, have seen some places with a couple thousand windmills generating power. There are even miniature solar cells that use light energy from even a match to power calculators. There are solar 12 volt chargers on the market for about 30 bucks. They don't put out a lot, but will maintain & even slowly charge a battery. Can get solar powered fans to put in car windows. Even on a cloudy day they will provide air circulation so your car doesn't get so hot inside while sitting in parking lot. If I were 50 years younger & had a mind capable of doing it, I would go the solar route, & work on improving effieiency. Keep those minds working. It is possible that someday you will reach a breakthrough, & be as famous as Franklin, Bell, Edison & others. Willie J
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|