Tractor Talk Discussion Board |
Re: A great homebrew generator plan
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greenbeanman in Kansas on December 06, 2004 at 20:44:05 from (4.244.189.59):
In Reply to: A great homebrew generator plan posted by Jake In Colorado on December 06, 2004 at 19:05:54:
Hi neighbor, I'm in the next state over, i.e. Kansas. When I was a kid my brothers and I played/experimented with all sorts of homebrew devices, nothing as grand a scale as you speak of however. I encourage you to proceed with the fun project. Be sure to start with a fully charged battery. Install an ampmeter on the line going to the motor, and an ampmeter on the line from the alternator to the battery. Check the difference. When you put the device into operation be sure to time it to see how long it takes for the battery to completely run down. Uh, hate to agree with the others, but it will fail to produce enough to keep operating. I would rather see you young men work on the capacitors and device needed to gather "ether" electricity courtesy Tesla's ether plate collector. There are books bearing his patent information, but as far as I know the capacitors and trigger devices do not exist today. To get you to also think along other energy lines, how about coming up with a device to gather the heat from household waste water? There are a few on the market, but I think one could be made better. Dishwasher water, washing machine water, etc. capatured to extract the heat from it to preheat incoming water heater water. Get the idea? How about relocating the compressors from freezers and refrigerators so that the heat is expelled from the house during the summer, and is used to help heat the house in the winter. Perhaps use the heat from them to preheat water heater water. Jake, I have faith in you young people. WE NEED young people like you to kick around ideas until they work and become reality. YOU GO GUY!!!! Never stop dreaming.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|