Tractor Talk Discussion Board |
Re: Does anyone know how to trun up a injector pum
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on November 07, 2004 at 15:40:47 from (142.177.98.77):
In Reply to: Re: Does anyone know how to trun up a injector pum posted by Ryan on November 07, 2004 at 04:39:00:
If you are not working it hard, then it is not getting the extra fuel anyway. A diesel will only get fueled up as it is loaded down. It's a little different idea than setting a rich mixture on a carb, where it is constantly too rich. So, if you are worried about working it too hard, just back off a gear, or load it a little lighter. Watch the smoke, and when it gets too dark for your liking, back off. Take care. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|