Re: Does anyone know how to trun up a injector pum

Posted by Rod F. on November 06, 2004 at 19:18:16 from (142.177.102.237):

In Reply to: Does anyone know how to trun up a injector pump. posted by krk on November 06, 2004 at 11:02:42:

Either take the pump off and have it calibrated at an injection pump shop, or put the tractor on a PTO dyno. I'm not aware of any way to rough a rotary pump like you have. Inline pumps can be field set with the right information. Don't take this the wrong way, but if you are asking how to do this, you should leave it alone. There are many things you ought to understand about pumps if you are going to play with them. As far as turning an engine up, in principle, I see nothing wrong with it, provided you are careful with it. Ag engines are usually set to make full power continously. The same engine could have an intermittent rating 20 -30 % higher. Generally, engine life is going to be shortened, especially if it is run at maximum power for extended periods. Using that power as a torque reserve or short bursts of intermittent power likely won't do too much if any harm. Again, if you decide to crank her, at least get it done with benefit of a dyno or calibrate the pump on a test stand. Take care.

Rod

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]