Re: OT Truck transmission cooler

Posted by Allan in NE on October 25, 2004 at 08:19:00 from (148.78.243.24):

In Reply to: Re: OT Truck transmission cooler posted by Jack B. Nimble on October 25, 2004 at 08:08:43:

Hi Jack,

I like to use either 5/16 or 3/8" steel brake lines (depending on the transmission), cut to length and use double flared or stout compression fittings to tie in. If you want to gauge the temperature of the transmission oil, grab it at that �out� port of the tranny. This is where it is the hottest.

Like I was telling Bob, I used to rebuild up there in North Dakota. They have some very high temperature summers and the winters are at the opposite side of the coin, often at 30 below or better for weeks on end.

Those guys are experts on towing with automatic transmissions; they see both sides of the question.

Allan

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]