Re: Head Gasket replacement

Posted by Redmud on October 12, 2004 at 06:28:43 from (216.167.146.118):

In Reply to: Head Gasket replacement posted by JD Jim A. on October 11, 2004 at 19:25:47:

Draw circles on thin cardboard {cereal box} with a compass a tad larger than the bore. cut em out as best you can. slide em down half inch or so in the bore. if you didn't do a good job on the cut out part, then a little wheel bearing grease will seal them up. when the block clean up is done, use a shop vac to suck the crud off the cardboard. this may sound like a lot of work but not as much as trying to get the crud out of the cylinders.
Redmud:

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]