|
Tractor Talk Discussion Board |
Re: Tire and rim sizes - who *really* knows?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gerald J. on October 07, 2004 at 07:57:23 from (67.0.109.80):
In Reply to: Tire and rim sizes - who *really* knows? posted by Jeff IA on October 06, 2004 at 19:44:02:
According to my old printed Goodyear Farm Tire Handbook (available on line these days) in the table "Approved Rim Contours" it says: 14.9-28/14.9R28 Recommended rim W13, Alternate rim W12. The proper tire for a 11" rim would be a 12.4-28. I had an 8N once with extra wide tires on the original rims. They were old, gray, and hard. And it cost the tire man lots of blood and sweat getting them off. The Ford parts book should mention the rim dimensions, perhaps the owner's manual mentions the rim options. There could have been several factory options. Most tractor tire books do have a list of approved rim contours. Gerald J.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
