Tractor Talk Discussion Board |
Re: Over-running coupler / Slip clutch on PTO shaft question
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by GEO on April 19, 1999 at 19:56:54:
In Reply to: Over-running coupler / Slip clutch on PTO shaft question posted by Rick K on April 19, 1999 at 19:49:03:
Sounds like you may have too long a roll pin holding it on, or you did not drive the pin in far enough to allow the center hub to spin by. The correct lenth for a roll pin for a Hub City is 2 inches. The pin must be of equal depth from each side of the housing. GEO
Follow Ups:
Post a Followup
|