Tractor Talk Discussion Board |
Re: ford 8n with back hoe/loader,need ruff weight?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nat on September 29, 2004 at 19:57:26 from (66.26.133.155):
In Reply to: Re: ford 8n with back hoe/loader,need ruff weight? posted by Gerald J. on September 29, 2004 at 19:03:54:
You know, I've never weighed an 8N and I have heard that factory weight was around 2400 lbs, But I've never seen 1 get into a 2700 lb weight class in antique tractor pulls without removing lots of parts. I would bet that most run of the mill N's will be over 3000, and the loader that went on most N's probably had 300 lbs of rust and dirt caked grease. These old tractors weigh more than most folks think they do. I heard some one say a Cub Farmall weighs 1300 lbs according to some chart they saw, maybe so, but again I expect that if you weigh the next 100 Cubs you see, I'll bet that the average will be close to 2000. Has anyone weighed their tractor to see how they compare to what some brochure says? I'd be interested to hear, Later, Nat
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|