Tractor Talk Discussion Board |
Re: Hydrolic problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on September 27, 2004 at 17:28:13 from (152.163.101.9):
In Reply to: Hydrolic problem posted by Johntow on September 27, 2004 at 06:51:59:
Well John, hydraulic cylinders can move mountains, if they're in good shape and can get air-free fluid to them. The pump and filter look new? How's your hydraulic fluid level? Motor is out of box failure and has a bad seal(s) maybe? Maybe former owner thought the original motor was the problem, but wasn't? Maybe a control valve is failing or sticking under pressure and not moving to the position you're directing it, not allowing fluid to move? "bucket won't move when someone puts a foot into it". Are you saying that you're releasing pressure and still won't go down, even when applying pressure? Double action control valve working with a two way cylinder, or two seperate control valves? I'm going to guess at one single two-way, and that may be where your problem is - sticking under pressure? If you meant "does move when someone puts a foot in it", then I'd be looking for leaking seals anywhere, including cylinders. But that's not what you said, so it doesn't sound like a cylinder is failing or has a leaky seal, otherwise would be dropping under load pressure instead of maintaining, or not budging to begin with. I know nothing about any "skid ster", but with hydraulics, a motor moves fluid to whatever direction one allows it to flow with a control valve, and the cylinders move accordingly. A filter keeps dirt, debris, and moisture out.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|