Tractor Talk Discussion Board |
Re: ZTRs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John (C-IL) on September 22, 2004 at 19:48:59 from (152.163.101.9):
In Reply to: ZTRs posted by Mitch78 on September 22, 2004 at 16:49:59:
My wife bought a TORO Z Master, 17hp Kawasaki and a 44" cut. It will mow as fast as you can stay in the seat. Don't be fooled by the Lowes/Menards/Farm Store cheapies, they may only cost $3000, but if you are mowing 2.5 acres you will trash one in a couple of seasons. We mow about 5 acres with the Toro and a Grasshopper. BTW, the Toro was about $4000 less than a comparable Grasshopper, damn they are proud of the brown paint.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|